Go Power! Smart Charger

The Go Power! Smart Charger was designed specifically to extend the life of deep-cycle batteries. With a unique microprocess or controlled electronic design, it offers multi-stage charging to accurately recharge and maintain batteries without electrolyte loss. It is ideal for wet cell batteries.

The Go Power! Smart Charger is a high frequency switching mode 3-stage battery charger and equipped with a micro controller and PFC circuit. This allows it to perform intelligent battery management and to provide highly reliable and power efficient operation.

Features

The Go Power! Smart Charger features a three-stage charging process, more sophisticated and faster charging than conventional transformer type chargers.

The charging stages are:

1. Bulk Stage: Constant current charging at a high voltage level at maximum amperage
2. Absorption Stage: Tapering current for the last 10-20% of charge
3. Float Stage: Lower voltage float mode to prevent electrolyte loss.

Its features include an LED display of battery charging state short circuit and over-temperature protection and a battery type selector switch. The high efficiency electronic design makes them the ideal choice as either a back-up charger or for use with generators.

Additional Features

• Faster charging than conventional chargers
• Three-stage charging: bulk, absorption and float modes
• Full output over a range of input voltages (85-135 VAC), ideal for generator charging
• Gel and lead-acid battery type selector switch
• Multiple battery bank charging (fully isolated outputs)
• Small and lightweight, CSA approved
• 12 V output